Siemens NCM S7 - Specifying the Local Connection Endpoint

Configuring Communication Connections
129
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
4.7.1 Specifying the Local Connection Endpoint
General Tab
This tab of the Properties dialog displays the parameters of the connection and a
local connection name for the UDP connection.
The local ID is identical to the ID in the NetPro connection table (STEP 7
connection configuration) and is shown here to illustrate the assignment.
Figure 4-22 Layout of the “General” Tab in the Properties Dialog for UDP Connections