43
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Installing and Starting the Ethernet CP
with STEP 7
To attach a SIMATIC station to Industrial Ethernet via the Ethernet CP, configure
the CP with the NCM S7 configuration software. The chapter explains the
following:
S How the CP is configured in the STEP 7 project
S How the various network configurations are managed (setting up access to
other systems)
S How to control and supply the CP with data using NCM S7
You will find further information in the following sources:
S When installing the Ethernet CP, please refer to the instructions in the manual
/1/ supplied with the Ethernet CP. This also contains further information about
the performance of the Ethernet CP .
S For more information about the functions and applications of STEP 7 in which
the NCM S7 option is integrated, please read the following topics:
– For using the help functions, read the section Working with STEP 7 in /6/.
– Configuring and assigning parameters to modules in /6/
– Configuring networks in /6/. You will find this information in the online help
with integrated in STEP 7 by selecting Help
"
Contents.
S You will find examples of configurations in the Primer /3/.
2
To Next Page
Loading...
