Installing and Starting the Ethernet CP with STEP 7
51
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Setting Addresses in the Configuration and Addressing for the First Time
The address settings described here are made on the CP only after you download
the configuration data.
With the latest Ethernet CPs, the situation is as follows:
To be able to reach the CP using these addresses before you download the
configuration data, you can address the CP using its default MAC address and
then supply it with project-specific address information.
How to do this is described in Section 2.3.
To Next Page
Loading...
