Siemens NK8223

Maintenance and diagnostics
64
Building Technologies
048_DMS_NK8000_ICC_MP4.40_A6V10062437_a_en.doc
Fire Safety & Security Products 06.2011
 Out scan: Set the NK82xx unit out of scan. After that, the In Scan command
will be available.
 Reset: Launch a reset of the NK82xx unit
 Synchronize date/time: Send a date & time message to the NK82xx unit.
 Update branch: Refresh the status line of the NK82xx unit.
 Vitality: Get and show the status of the NK82xx unit in a pop-up window.
Note: The command menu options are reduced if the selected branch is
not connected or is set as out of scan.
 Send commands to all NK82xx units by selecting the NK8000 icon on the top
left and clicking the command in the pop-up menu (Fig. 49). The command list
in
cludes:
 Get the NS8210 Log Files: Upload and show the NS8210 driver logs.
 Get all versions: Get and display the version of all NK82xx units.
 Synchronize date/time: Send a date & time message to all NK82xx units.
Fig. 49 Pop-up command menu for all NK82xx branches.
Filtering and searching the NK82xx list
The upper frame presents two selection fields to filter and select branches respec-
tively.
 Filter the NK82xx list by selecting on of the options in the Filter by list and click-
ing Apply filter (Fig. 50).
Fig. 50 Filtering NK82xx branches
 Search and mark a specific NK82xx unit by selecting one of the searching op-
tions and entering the value to search. Then, clicking Apply mark results in the
corresponding NK82xx units being marked (Fig. 51). At that point, using the
Marked br
anches filtering option allows for showing the selected unit only.
The list of searching criteria includes:
 Branch number: Specify the branch number. For example 132 as in Fig. 51.