Hardware installation
NE8000 cabinets
5
35
Building Technologies
A6V10062437_a_en
Fire Safety & Security Products 30.06.2013
The VAC power supply wires (1.5 mm
2
) should be connected as illustrated in Figure
VAC power connection
.
WARNING
Careful attention should be paid to the correct connections of VAC power lines.
Ground
Phase
Neutral
Input VAC
1.5 mm
2
wires
VAC power connection
Wires pass through 20 mm (cut-out) holes at the top of the cabinet (see Figure
Top
view of NE8000 cabinet
), and continue behind the cabinet to pass through the rear-
side cavity to the entrance hole (see Figure
Wiring (1) – Front view of cabinet (arrow
indicates cut-out holes)
and Figure
Wiring (2) – Entrance hole indicated by arrow
)
where they should be anchored securely before being connected to the screw
terminators.
20 mm hole cut-outs
Top view of NE8000 cabinet
To Next Page
Loading...
