Siemens NK8235

Maintenance and diagnostics
The NW8204 maintenance and diagnostic tool
9
73
Building Technologies
A6V10062437_a_en
Fire Safety & Security Products 30.06.2013
This file is always present, and contains detailed technical information about the
behaviour of the software application running on the NK8000. For example, if it wasn’t
possible to open an internal queue during the initialisation phase, that message is
saved to this file.
The information in this file is not meant to be used by filed engineers on site. In case of
technical problems, the DIAGNO.LOG file can be transmitted to the technical support
for a specific analysis.
EEProm.LOG
You create this file by selecting the Save EEProm on File button. This file contains
information about the NK8000 hardware status stored on the EEProm. For example, if
it wasn’t possible to use the serial interface on COM3 because the serial add-on board
is broken, that message is saved to the EEProm.
Note: Every time you select the Save EEProm on File button, you overwrite any
existing EEProm.LOG file.
A detailed description of the EEProm log entries is provided in the table here below.
ID Message text Meaning
0 EV_EEPROM_NULL —
1 EV_EEPROM_INIT EEProm initialization
2 EV_EEPROM_START NK8000 unit restart
3 EV_EEPROM_NOT_ALIGNED EEProm not aligned
4 EV_EEPROM_NO_ETH_INIT Ethernet initialization failed
5 EV_EEPROM_TAMPER_OPEN NK8000 unit box opened
6 EV_EEPROM_TAMPER_CLOSE NK8000 unit box closed
8 EV_EEPROM_NO_SER0_INIT COM1 initialization failed
9 EV_EEPROM_NO_SER1_INIT COM2 initialization failed
10 EV_EEPROM_NO_SER2_INIT COM3 initialization failed
11 EV_EEPROM_NO_SER3_INIT COM4 initialization failed
12 EV_EEPROM_SER0_ERROR COM1 error
13 EV_EEPROM_SER1_ERROR COM2 error
14 EV_EEPROM_SER2_ERROR COM3 error
15 EV_EEPROM_SER3_ERROR COM4 error
16 EV_EEPROM_DATE_TIME Date and time changed within delta threshold
17 EV_EEPROM_NEW_DATE_TIME Date and time changed over delta threshold
18 EV_EEPROM_RESET Reset command
19 EV_EEPROM_EMERGENCY Restart in emergency mode
20 EV_EEPROM_FTP_SESSION FTP session opened
21 EV_EEPROM_CONFIG_CHANGE Configuration file changed
22 EV_EEPROM_SW_CHANGE Software version changed
23 EV_EEPROM_CPU_CHANGE CPU changed