Siemens NK8235

Maintenance and diagnostics
9
The NW8204 maintenance and diagnostic tool
74
Building Technologies A6V10062437_a_en
Fire Safety & Security Products 30.06.2013
24 EV_EEPROM_ETH_PNP_UPDATE Ethernet EEProm update
25 EV_EEPROM_ETH_PNP_ERROR Ethernet EEProm update failed
34 EV_EEPROM_DLL_LOAD_FAILED DLL load failure
35 EV_EEPROM_DLL_EXCLUDED DLL excluded from round-robin schedule
36 EV_EEPROM_DLL_OVERRUN DLL response time over threshold 1
37 EV_EEPROM_DLL_VER_ERR DLL version error
38 EV_EEPROM_DLL_INIT_ERR DLL initialization error
39 EV_EEPROM_DLL_OVERTIME DLL response time over threshold 2
40 EV_EEPROM_DLL_TIMEOUT DLL response time over threshold 3
41 EV_EEPROM_DLL_EVENT DLL diagnostic event
42 EV_EEPROM_HW_MISMATCH PIC24 microcontroller init detected a
hardware version different from version in
EEProm
43 EV_EEPROM_PIC24_FLASH_FAILU
RE
PIC24 microcontroller init failed to write the
microcontroller flash memory
44 EV_EEPROM_PIC24_PROGRAMM
ED
PIC24 microcontroller init wrote a new
firmware into the microcontroller flash
memory
45 EV_EEPROM_PIC24_WRONG_HEX PIC24 microcontroller init detected a wrong
firmware into the microcontroller
46 EV_EEPROM_HW_FAILURE Unable to retrieve information from the
EEProm or from the PIC24 microcontroller
47 EV_EEPROM_FOUND_USB USB mass storage device plugged
48 EV_EEPROM_REMOVE_USB USB mass storage device unplugged
49 EV_EEPROM_FOUND_SD SD card plugged
50 EV_EEPROM_REMOVE_SD SD card unplugged
EVENT.LOG
This file is present only after the EEProm is full for the first time. It contains (up to) the
four most recent backups of the EEProm.LOG file.
Note: EEProm.LOG and EVENT.LOG may not be available for some older NK822x
hardware versions.
Upload of diagnostic files
1. Select one or more of the following diagnostic files:
- DIAGNO.LOG
- EEProm.LOG
- EVENT.LOG
2. Select Upload File.
 The browsing window opens.