2 / 18
Siemens RDF600KN, RDF600KN/VB, RDF600KN/S A6V11425204_en--_d
Smart Infrastructure Semi flush-mount communicating room thermostats 2020-02-21
Additional RDF600KN/S features:
· Four buttons to control KNX actuators via KNX S-mode
(functions: switching, dimming, blinds control, 8-bit scene)
Use
Room temperature control (heating or cooling) in individual rooms and zones by
means of:
· 2-pipe fan coil units
· 2-pipe fan coil units with electric heater
· 4-pipe fan coil units
· Compressors in DX-type equipment
· Compressors in DX-type equipment with electric heater
The thermostats control:
· One 1-speed or 3-speed fan
· One or two on/off valve actuators
· One on/off valve actuator and one 1-stage electric heater
· One 3-position valve actuator
· One 1-stage compressor in DX-type equipment, or one 1-stage compressor with
electric heater
Used in systems with:
· Heating or cooling mode
· Automatic heating/cooling changeover
· Manual heating/cooling changeover
· Heating and cooling mode (e.g. 4-pipe system)
The room thermostats are delivered with a fixed set of applications.
The relevant application is selected and activated during commissioning using one
of the following tools:
· Synco ACS
· ETS
· Local DIP switch and HMI
To Next Page
Loading...
Need help?
General
