Need help?Do you have a question about the Siemens RDF800KN Series and is the answer not in the manual?
General| Product Series | RDF800KN Series |
|---|---|
| Category | Thermostat |
| Manufacturer | Siemens |
| Communication | KNX |
| Protection Rating | IP30 |
| Type | Room thermostat |
| Control Function | Heating and Cooling |
| Display | LCD |
| Mounting | Wall-mounted |
Explains how to set desired temperature values.
Specific configurations for fan coil units.
Specific configurations for universal systems.
Specific configurations for heat pumps.
Specific heating configurations for RDD810KN/NF.
Detailed setup for 2-pipe fan coils.
Setup for 2-pipe fan coils with electric heat.
Detailed setup for 4-pipe fan coils.
Specific configurations for chilled/heated ceilings.
Setup for compressor-based systems.
Specific heating configurations for RDD810KN/NF.
Detailed fan control options.
How the thermostat communicates on the KNX bus.
Settings to optimize thermostat performance.
List of basic adjustable parameters.
List of advanced parameters and diagnostic tools.
Steps to configure the thermostat after installation.
Engineering Tool Software for KNX system configuration.
Application and Configuration Software for system setup.
Identifies and describes the thermostat's connection points.
To Next Page