Certification
6
The RUGGEDCOM RS910 device has been thoroughly tested to guarantee its
conformance with recognized standards and has received approval from recognized
regulatory agencies.
6.1 Approvals
This section details the standards to which the RUGGEDCOM RS910 complies.
6.1.1 CSA
This device meets the requirements of the following Canadian Standards Association
(CSA) standards under certificate 1550963:
• CAN/CSA-C22.2 No. 62368-1
Information Technology Equipment – Safety – Part 1: General Requirements (Bi-
National Standard, with UL 62368-1)
• UL 62368-1
Information Technology Equipment – Safety Part 1: General Requirements
• CAN/CSA-C22.2 No. 0-M91
General Requirements - Canadian Electrical Code, Part II
• CAN/CSA-C22.2 No. 142-M1987
Process Control Equipment Industrial Products
• CAN/CSA-C22.2 No. 213-16
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class
III, Divisions 1 and 2 Hazardous (Classified) Locations (Bi-National Standard with
ANSI/ISA-12.12.01-2016)
• UL 916
Standard for Energy Management Equipment
• ANSI/ISA-12.12.01-2015
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class
III, Division 1 and 2 Hazardous (Classified) Locations
It is specifically approved for use in hazardous locations with the following markings:
• Class I, Division 2, Groups A, B, C, D
RUGGEDCOM RS910
Installation Manual, 04/2021, C79000-G8976-1029-12
35
To Next Page
Need help?
General