RUGGEDCOM RSG2100
Installation Guide
Chapter 2
Installing Device
Configuring the Device 19
Pin
RJ45
Male
DB9
Female
Name Description Comment
5 2 RxD Receive Data
(to DTE)
6 3 TxD Transmit Data
(from DTE)
7 8 CTS
b
Clear to Send
8 7 RTS
b
Read to Send
1 9 RI
c
Ring Indicator
a
The DSR, DCD and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
c
RI is not connected.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the ROS console
and Web interfaces via the device's IP address. For more information about available ports, refer to Chapter3,
Communication Ports.
Section2.9
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
To Next Page
Loading...
Need help?
General