Siemens RUGGEDCOM RSG907R - Page 24

Installing the Device
2.5.2Wiring Examples
c. Connect the ground wire to the
chassis/ground terminal on the
terminal block.
4. Connect the chassis ground screw to ground (Potential Earth). It is
recommended to terminate the ground connection with an M4 ring or spade
lug, and then torque to 1.7 N·m (15 lbf-in).
2
1
1
M4 Screw
2
M4 Ring Lug
Figure2.10 Chassis Ground Connection
5. Connect the external power supply to a power source. The Power LED on the
device will turn green when power is being supplied to the device.
2.5.2 Wiring Examples
The following illustrate how to connect single and dual power supplies to the device.
RUGGEDCOM RSG907R
Installation Manual, 10/2020, C79000-G8976-1387-10
15