6.11.01 S46 US DRAFT A31008-H5450-A5-*
94
Specifications
Declaration of conformity
Exposure to radio frequency sig-
nals
Your wireless handheld portable
telephone is a low power radio trans-
mitter and receiver. When it is ON, it
receives and also sends out radio
frequency (RF) signals.
In August 1996, The Federal Com-
munications Commission (FCC)
adopted RF exposure guidelines
with safety levels for hand-held wire-
less phones. Those guidelines are
consistent with the safety standards
previously set by both U.S. and inter-
national standards bodies:
American Natinal Standards Institute
(ANSI) C95.1 (1992)
National Council of Radiation Protec-
tion and Measurement (NCRP) Re-
port 86 (1986)
International Commission of Non-
Ionizing Radiation Protection
(ICNIRP) 1996
Ministry of Health (Canada) Safety
Code 6
Those standards were based on
comprehensive and periodic evalua-
tions of the relevant scientific litera-
ture. For example, over 120 scien-
tists, engineers, and physicians from
universities, government health
agencies, and industry reviewd the
available body of research to devel-
op the ANSI standard (C95.1).
The design of your phone complies
with the FCC guidelines (and those
standards). For additional informati-
on concerning exposure to radio fre-
quency signal, see the statement by
the FDA at the end of this user gui-
de.
Technical data
GSM 900 class: 4 (33 dBm)
GSM 1900 class: 1 (30 dBm)
TDMA 800 class IV: (0.6 W ERP)
TDMA 1900 class IV: (0.6 W ERP)
Weight: 123g/4.3OZ
Dimensions: 118 x 46 x 21mm
(94 cm
3
)
Operating voltage: 3.8 Volts
Standby time:
GSM: Up to 260hr
TDMA: Up to 150hr
Talk time:
GSM: Up to 6hr
TDMA: Up to 150 minutes
SIM card: 3 Volt
To Next Page
Loading...
