SIEMENS PTE LTD
S65 Level 2 Service Manual
Copyright © Siemens Pte Ltd. Siemens Technical Support Centre
All Rights Reserved
ICM MP CCQ SLI RHQ Page 14 of 35 Internal Use Only
7 Disassembly of S65 / SP65
Note: ESD concept; the internal circuits will be more susceptible to ESD because of
the use of exchangeable housing. The construction of the internal block must be/is
designed, in the best possible way, to protect the circuit against sparks.
Note: All described procedures exclusive camera replacement
are valid for S65 and
SP65. Therefore form this line onwards the name S65 includes SP65 too.
The keypad must be completely closed to prevent any occurrence of an ESD
disruptive discharge.
The SIM contacts may be open, thus reachable for ESD contact discharge. This
could lead to damage or destruction of the S-Gold pins.
It is a requirement for the service personnel to observe ESD protection rules while
performing servicing the S65 / SP65.
Step 1
Front view of the S65 / SP65
Step 2
Back View of the S65 / SP65
Step 3
To remove the battery, lift the battery tab using your
thumb as shown.
Step 4
Remove the SIM card by sliding it downwards as indicated
by the arrow.
To Next Page
Loading...
