Click "Restart Router" button or re-power the router to work with the new parameters.
Similarly, when ETH Adapter CN go on external network communication,you need to set the port
simulation on the router connected with the server ETH Adapter CN, input the IP address of
router in the IE browser of PC connected with this router and then enter the virtual server setting
interface of the router.
The server port = local port of server ETH Adapter CN; IP address = IP address of server ETH
Adapter CN; Select the "Enable", click "Save" button to save these configured parameters.
Set the parameters of server ETH Adapter CN as below:
- 29 -
To Next Page
Loading...
