Approvals, certificates, standards
9.4 X-300EEC product group
SCALANCE X-300
244 Operating Instructions, 02/2012, A5E01113043-12
WARNING
Permitted expansions
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
● Installation guidelines
The product meets the requirements if you adhere to the installation and safety notices
contained in this documentation and in the following documentation when installing and
operating the product.
The very latest documentation is available on the Internet!
You will find the installation instructions documentation on the Internet on the pages of
Siemens Industry Automation Customer Support under the following entry ID:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736 (http://support.automation.siemens.
com/WW/view/en/8763736)
– EMC Installation Guideline, Planning Guide
28518276 (http://support.automation.siemens.
com/WW/view/en/28518276)
● Working on the product
To protect the product process from electrostatic discharge, personnel must first
discharge any electrostatic charge from their body before touching the product.
NOTICE
The product was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
To Next Page
Loading...
Need help?
General
