Approvals, certificates, standards
9.4 X-300EEC product group
SCALANCE X-300
Operating Instructions, 02/2012, A5E01113043-12
245
Machinery directive
The product is a component in compliance with the EC Machinery Directive 2006/42//EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 2006/42/EEC.
Note
Note for the manufacturers of machine
s
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EEC for this
product.
Explosion protection directive (ATEX)
All variants of the X-300EEC with 24 V DC power supply meet the requirements of the EC
directive 94/9/EC "Equipment and Protective Devices for Use in Potentially Explosive
Atmospheres".
WARNING
When using (installing) SIMATIC NET products in hazardous area zone 2, make absolutely
sure that the associated conditions are adhered to:
• "Approval of SIMATIC/ SIMATIC NET Products for Direct Installation in Ex-Zone 2"
You will find this on the Internet on the pages of Siemens Industry Automation Customer
Support under the following entry ID:
33118441 (http://support.automation.siemens.
com/WW/view/en/33118441)
"Entry list" tab > entry type "Certificates"
ATEX code:
All variants of the X-300EEC with power supply 24 V DC have the following approval:
II 3 G Ex nA II T4
They meet the requirements of the following standards:
● EN 60079-15 : 2005 (electrical apparatus for potentially explosive atmospheres; Type of
protection "n")
● and EN 60079-0:2006
IEC 61850-3 (EN55022 / CISPR22 CLASS A)
The product meets the requirements of the standard IEC 61850-3
(EN55022 / CISPR22 CLASS A).
To Next Page
Loading...
Need help?
General
