4
Arc flash hazard, hazardous voltages and high-speed moving parts.
Will cause death, serious injury or property damage.
To avoid arc flash burns, electrical shock and entanglement in moving parts,
only qualified personnel should work on or around this equipment after
becoming thoroughly familiar with all danger or warning notices, and
procedures contained herein. Personnel must observe all applicable
regulations (e.g., OSHA), follow all requirements of NFPA 70E and adhere to
specific operating procedures applicable to the installation. Use appropriate
personal protective equipment (PPE) for the voltage and arc flash incident
energy exposure.
Arc flash hazard and hazardous voltages.
Will cause death, serious injury or property damage.
Always de-energize and ground the equipment before maintenance. Read
and understand this instruction manual before using equipment.
Maintenance should be performed only by qualified personnel. The use of
unauthorized parts in the repair of the equipment or tampering by
unqualified personnel will result in dangerous conditions which will cause
death, severe injury or equipment damage. Follow all safety instructions
contained herein.
Introduction
To Next Page
Loading...
Need help?
General
