SIMATIC IPC547G - Windows 7 Ultimate, 32-bit, MUI
A5E42356221-AA, 07/2017
5
In contrast to the procedure described in the manual for 64-bit versions of the operating system, Windows 7 Ultimate, 32-bit,
is installed as follows:
1. If your device has no DVD drive, connect an external USB DVD drive to the USB port.
2. Insert the Recovery DVD into the DVD drive.
3. Reboot the device.
4. Press the <F12> key when the device boots and keep it pressed.
The "Boot Menu" is displayed when initialization is completed.
5. Select the optical drive using the cursor keys.
Example of internal drive:
P5: HL-DT-ST DVDRAM GUD0N
6. Confirm the selection by pressing ENTER.
7.
press any key when you see the following prompt to install the operating system from the Recovery DVD.
Press any key to boot from CD or DVD ..
After a few seconds, you will see the "Install Windows" installation program.
8. Now follow the instructions of the installation program.
You can find additional information on this in the next section.
Partitions in the factory state
The following information applies to data storage media ≥ 200 GB (MBR formatted).
First BOOT 100 MB Automatically set up by installation
To Next Page
Loading...
Need help?
General
