Siemens SIMATIC NET RUGGEDCOM RSG907R Installation Guide

Chapter 2
Installing the Device
RUGGEDCOM RSG907R
Installation Guide
6 General Procedure
Section2.1
General Procedure
The general procedure for installing the device is as follows:
IMPORTANT!
The user is responsible for the operating environment of the device, including maintaining the integrity
of all protective conductor connections and checking equipment ratings. Make sure to review all
operating and installation instructions before commissioning or performing maintenance on the
device.
1. Review the relevant certification information for any regulatory requirements.
For more information, refer to Section6.1, “Approvals”.
2. Unpack and inspect the device.
For more information, refer to Section2.2, “Unpacking the Device”.
3. Mount the device.
For more information, refer to Section2.4, “Mounting the Device”.
4. Connect the failsafe alarm relay.
For more information, refer to Section2.5, “Connecting the Failsafe Alarm Relay”.
5. Connect power and ground the device.
For more information, refer to Section2.6, “Connecting Power”.
6. Connect the device to the network.
For more information, refer to Section2.7, “Connecting the Device to the Network”.
7. Configure the device.
For more information, refer to Section3.2, “Configuring the Device”.
Section2.2
Unpacking the Device
When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.

Siemens SIMATIC NET RUGGEDCOM RSG907R Specifications

General

Brand	Siemens
Model	SIMATIC NET RUGGEDCOM RSG907R
Category	Switch
Language	English