Chapter 6
Certification
RUGGEDCOM RSG907R
Installation Guide
36 CSA/Sira
• CAN/CSA-C22.2 No. 60079-0:15
Explosive Atmospheres – Part 0: Equipment – General Requirements
• CAN/CSA-C22.2 No. 60079-15:16
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test and Marking of Type of
Protection "n" Electrical Apparatus
• ANSI/UL 60950-1-2014
Information Technology Equipment – Safety Part 1: General Requirements
• ANSI/ISA-12.12.01-2015
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Division 1 and 2 Hazardous
(Classified) Locations
• ANSI/UL 60079-0:13
Electrical Apparatus for Explosive Gas Atmospheres – Part 0: General Requirements
• ANSI/UL 60079-15:13
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Type of Protection "n"
The device is marked with a CSA symbol that indicates compliance with both Canadian and U.S. requirements.
It is specifically approved for use in Division 2 and Zone 2 hazardous locations with the following markings:
• Class I, Division 2, Groups A, B, C, D T4
• Ex nA nC IIC T4 Gc
• Class I, Zone 2, AEx nA nC IIC T4 Gc
This device meets the requirements of the following International standards under certificate IECEx CSA
18.0007X:
• IEC 60079-0:2011
Explosive Atmospheres – Part 0: Equipment – General Requirements
• IEC 60079-15:2010
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test and Marking of Type of
Protection "n" Electrical Apparatus.
It is specifically approved for use in Zone 2 hazardous locations with the following markings:
• Ex nA nC IIC T4 Gc
Section6.1.2
CSA/Sira
When marked with the following ATEX marking, this device is approved for use in Zone 2 hazardous locations
under certificate Sira 18ATEX4069X.
NOTE
For the maximum ambient temperature, refer to the hazardous location label affixed to the device.
To Next Page
Loading...
Need help?
General