3
3-5
Programming Device PG 740
C79000-G7076-C742-01
You connect external multisynchronous monitors to the right-hand casing
side panel with the standard VGA connector. We recommend you use
Siemens monitors.
You must switch the PG 740 off before connecting the monitor cable. You
will find more details in the connector pinout in Chapter 7.
Monitor socket connector
Figure 3-3 Connecting the Monitor
Connect the monitor as follows:
1. Switch off the PG 740 and the monitor.
2. Open the port cover on the left-hand casing side panel.
3. Plug the monitor cable into the VGA socket connector.
4. Plug the other end of the monitor cable into the monitor.
5. Adjust the monitor settings with the SETUP program.
You can plug an additional graphics card into one of the two ISA slots for
special applications.
Proceed as follows:
1. Switch off the PG 740 and the monitor.
2. Open the cover for the expansion module connectors on the left-hand
casing side panel.
3. Plug the monitor cable into the VGA socket of the graphics card.
4. Connect the monitor cable to the monitor.
5. Adjust the monitor settings with the SETUP program.
Recommended
Monitors
Connecting
Monitors
Additional
Graphics Card
Connecting
Monitors to
Additional
Graphics Cards
Starting Up the PG 740
To Next Page
Loading...
