Need help?Do you have a question about the Siemens Simatic PG 740 and is the answer not in the manual?
General| Form Factor | Proprietary |
|---|---|
| Maximum RAM | 32 MB |
| Graphics Card | Integrated |
| Display | 10.4" TFT |
| Operating System | MS-DOS, Windows 3.1 |
| Ports | Serial, Parallel, VGA |
| Expansion Slots | PCMCIA |
Highlights the benefits of the PG 740 compared to standard PCs.
Instructions for unpacking the programming device and checking contents.
Steps for setting up the PG 740 on a desk or table.
Overview of the front panel components.
Information about the PG 740's TFT color display specifications.
Details on keyboard layout, keys, and ergonomics.
Information on the diskette and hard disk drives.
How to connect the PG 740 to the power source.
Connecting printers and monitors to the PG 740.
Programming S5 EPROMs and EEPROMs.
Reading, programming, or erasing SIMATIC memory cards.
Inserting and using PCMCIA interface cards.
Connecting the PG 740 via V.24 or TTY.
How to install ISA or PCI expansion modules.
Guide to installing SIMM memory expansion cards.
Using the SETUP program for system configuration.
Table listing common errors, causes, and remedies.
To Next Page
