Siemens Simatic PG 740 - The Exit Menu

5
5-20
Programming Device PG 740
C79000-G7076-C742-01
5.1.5 The Exit Menu
The setup program is always terminated using this menu.
PhoenixBIOS Setup-Copyright 1985-95 Phoenix Technologies Ltd.
Item Specific Help
F1
ESC
Help
Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Previous Values
Exit after writing all changed SETUP
item values to CMOS.
Sub-Menu
Save Changes & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Changes
Main Security Power Exit
Advanced
Figure 5-13 “Exit” Submenu
Save Changes &
Exit
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Á
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
All changes are saved; a system restart is carried out with the new
parameters.
Exit Without
Saving Changes
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
All changes are rejected; a system restart is carried out with the old
parameters.
Get Default
Values
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Á
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
All parameters are set to safe values. The hard disk must be entered
explicitly.
Load Previous
Values
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Á
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
The last saved values are coded again.
Save Changes
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Saving of all setup entries.
The Exit Menu
Configuring the PG 740