iv
Programming Device PG 740
C79000-G7076-C742-01
If you have any questions concerning subjects not covered in the manual, just
get in touch with the Siemens representative in your area.
If you have any questions on the manual itself or would like to make remarks
or suggestions, please complete the reply card at the end of the manual. We
would also appreciate it if you would include your own personal opinion on,
and appraisal of, the manual on the reply card.
The manual contains both the most important instructions for starting up and
using the programming device, as well as reference sections you will only
require in special cases.
Before you use the PG 740 for the first time, read Chapter 2 on the PG 740’s
components and functionality.
Chapter 3 describes the basic steps necessary for starting up the PG 740. This
section also contains instructions for working with memory cards for
programmable controllers and for connecting the programming device to
other devices.
Chapter 4 describes how to expand your PG 740 (installation of memory
expansion or additional modules). Please observe the safety notes.
Modifications to the system hardware may make it necessary for you to adapt
the original hardware configuration. Chapter 5 tells how to proceed in this
case.
Chapter 6 will tell you how to deal with simple faults that you can diagnose
and, in some cases, eliminate yourself.
Chapter 7 contains hardware addresses, interrupt assignments and
information on connecting cables.
The glossary explains important terms.
The index will enable you to quickly find passages in the text pertaining to
important keywords.
Queries
Pointers through
the Manual
Installation
Startup
Expansion
Configuration
Error/Fault
Diagnostics
Reference Data
Glossary
Alphabetical Index
Preface
To Next Page
Loading...
