4
4-11
Programming Device PG 740
C79000-G7076-C742-01
!
Caution
Risk of damage!
The electronic components of the printed-circuit boards are extremely
sensitive to electrostatic discharge. Please observe the guidelines for
electrostatically sensitive devices (ESD guidelines), otherwise the module or
device may be damaged.
You plug expansion modules in as follows:
1. Open the unit as described in Section 4.1.
2. Remove the dummy plate on the casing side panel.
3. Plug the module into a free slot.
4. Bolt the module backplane to the casing side panel.
5. Close the unit (Section 4.8)
Plugging in the
Module
PG 740 Expansions
To Next Page
Loading...
