Siemens SIMATIC RTU3041C - Page 64

2 Engineering
Securely Connecting RTU3041C to TeleControl Server Basic
Entry ID: 109739240, V3.0, 07/2021
64
© Siemens AG
2021 All rights reserved
15. Set the following settings for the analog input "gpsLatitude (GPS0)":
– Transmission method: (Event (only current values))
– Trigger: Change
– Transfer mode: Buffered transfer
16. Set the following settings for the analog input "gpsLongitude (GPS1)":
– Transmission method: (Event (only current values))
– Trigger: Change
– Transfer mode: Buffered transfer
17. Set the following settings for the counter input "visibleSatellites (GPS3)":
– Transmission method: (Event (only current values))
– Trigger: Change
– Transfer mode: Buffered transfer
18. Set the following settings for the counter input "timeLastPosition (GPS4)":
– Transmission method: (Event (only current values))
– Trigger: Change
– Transfer mode: Buffered transfer
19. Then click "Apply".