Securely Connecting RTU3041C to TeleControl Server Basic
Entry ID: 109739240, V3.0, 07/2021
2.2.4 Configuring OPC UA Clients (UaExpert)
This section shows you how to monitor the data points of the TCSB via OPC UA.
In order to securely observe the data points via the internet, the following is
required:
– "UaExpert" is installed on your PC.
– SINEMA Remote Connect Client is installed on your PC.
– The VPN connection has been established (Section 2.2.1).
– The configuration of the RTU3041C is loaded into the RTU (Section 2.2.2).
– The configuration of the TCSB is completed (Section 2.2.3).
In order for the OPC UA Server of the TCSB to be accessible from the OPC UA
Client, the VPN connection must first be established. This is necessary because
the TCSB is only accessible via the LAN port of the SINEMA Remote Connect
Server that has been approved for the user group "RTU".
Ensure that the TCSB port "4852" is enabled for remote access in the firewall of
the PG/PC "TCSB".
To Next Page
Loading...
Need help?
General