Siemens SIMATIC S5-95U - Page 106

Index S5-95U, Second Serial Interface
F
Footers 4-16
Frame length 4-15
FT1 Footers
FT2 Footers
H
HD1 Headers
HD2 Headers
Headers 4-16
I
Idle state 3-20, 3-21
Initialization conflict 3-8, 3-24
Input buffer 3-5, 4-4
Integrated blocks E-1
Interface 1-7
- Assignment 1-8
Interface SI1
- Possible functions 1-5
Interface SI2
- Possible functions 1-5
Internode communication E-3
Interpreting mode 4-10
Interrupt reaction time E-2
K
KBE Coordination byte
KBS Coordination byte
KC format
- Control character in 4-16
L
Left-hand margin width 4-16
Length parity 3-19
LF 4-16
Line length 2-4, 3-3, 3-4,
4-2,4-3
Lines per page 4-16
LM Left-hand margin width
LPP Lines per page
M
Master 2-1
Master function A-1, B-1
Master/slave principle 2-1
ME End-of-text identifier
Message protocol
- Generate 4-17
ML Message length
MOD Mode number
Mode 4-4, 4-5, 4-13
- Interpreting 4-10
- Non-interpreting 4-10, 4-15
Mode number
- for ASCII 4-10
- for computer link 3-12
N
NAK 3-18, 3-20, C-1
Net data 3-5, 4-4
Non-interpreting mode 4-10
O
OP function 1-6
Operator control and process monitoring
systems 1-2
Output buffer 3-5, 4-4
P
PAR Parameter set
Parameter block 2-6, 3-10, 4-8
Parameter set
- ASCII 4-12, 4-13
- Default for ASCII driver B-3
- Default for computer link B-5
- for computer link 3-12
Parameterization error A-3
Parameters
- Set on printer 4-17
Parity
Parity bit 3-13, 4-14
Pin assignment
- S5-95U (TTY active) 3-3, 4-2
- S5-95U (TTY passive) 3-4, 4-3
PLC scan cycle load E-2
PN Position of the page number
Point-to-point link 1-4, B-2
Point-to-point master 2-2
- Pin assignment (TTY active) 2-4
Point-to-point slave 2-2
- Pin assignment (TTY passive) 2-4
Position of the page number 4-16
PRI Priority
PRINTER 4-1
PRTY Parity
Printer DR 211
- Pin assignment 4-3
Printer parameter blocks 4-17
Priority 3-11, 3-14, 3-24
Programmer bus number A-1, B-2
Programmer function 1-4, 1-5, 1-6
2 EWA 4NEB 812 6095-02