CAUTION
The synchronization module contains a laser system and is classified as a "CLASS 1 LASER PRODUCT" in accordance
with IEC 60825-1.
Can cause personal injury.
Avoid eye contact with the laser beam. Do not open the housing. Read the information in the documentation
(https://support.industry.siemens.com/cs/ww/en/view/86140384).
WARNING
Personal injury due to uncontrolled movement
When using Motion Control, uncontrolled movements can occur which result in personal injury of unknown extent.
Follow the safety instructions described in the Motion Control function manuals
(https://support.industry.siemens.com/cs/ww/en/view/86140384).
Electromagnetic Compatibility
The product is intended for operation in the Industrial EMC environment class.
Ensure that your automation system is installed in compliance with EMC requirements, as described in the documentation
(https://support.industry.siemens.com/cs/ww/en/view/86140384) for the product.
NOTICE
Interference emission / Interference immunity
Operation of the product can cause radio interference in residential areas.
If higher EMI is expected at the place of use than is intended for the industrial area according to EN61000-6-2, additional
measures are required (e.g. ESD, overvoltage protection).
ATEX-/UKEX device intended for use in hazardous area
If the product is intended for use in a potentially explosive atmosphere (gas/air or gas/dust mixture), observe the special
information in the documentation (https://support.industry.siemens.com/cs/ww/en/view/86140384). The intended use (e.g.
ATEX zone, degree of protection, temperature class) is indicated on the product (in the declaration of conformity and usually
also on the nameplate).
NOTE
As a rule, country-specific requirements for the operator also apply when a product is used in a potentially explosive
atmosphere (e.g. Directive 1999/92/EC for the EU).
WARNING
Pulling or plugging a module is prohibited in the hazardous area.
When you pull or plug a module or plug-in connector during operation, there is a risk of sparking. Sparks can cause an
explosion in the hazardous area; death or serious physical injury as well as damage to property can result.
Do not pull or plug the module or the plug-in connectors until one of the following two conditions is met: The area is no
longer hazardous or the device and its plug-in connectors are de-energized.
10
Compact Operating Instructions
A5E51692496-AC, 06/2023
To Next Page
Loading...
