Siemens Simatic S7-300 - Project Engineering

Requirements for use
3.2 Project engineering
CP 343-1 Lean
Equipment Manual, 01/2023, C79000−G8976−C198−09
25
CPU
Order number
CPU 317F-2 DP
6ES7317-6FF00-0AB0
6ES7317-6FF03-0AB0
6ES7317-6FF04-0AB0
6AG1317-6FF04-2AB0
CPU 317F-2 PN/DP
6ES7317-2FJ10-0AB0
6ES7317-2FK13-0AB0
6ES7317-2FK14-0AB0
6AG1317-2FK14-2AB0
6AG1317-2FK14-2AY0
CPU 317T-2 DP
6ES7317-6TJ10-0AB0
6ES7317-6TK13-0AB0
CPU 317T-3 PN/DP
6ES7317-7TK10-0AB0
CPU 317TF-3 PN/DP
6ES7317-7UL10-0AB0
CPU 318-2 DP
6ES7318-2AJ00-0AB0
CPU 319-3 PN/DP
6ES7318-3EL00-0AB0
6ES7318-3EL01-0AB0
CPU 319F-3 PN/DP
6ES7318-3FL00-0AB0
6ES7318-3FL01-0AB0
Table 3- 2 Use of the CP with C7 control systems
C7
Order number
C7-613
6ES7613-1CA01-0AE03
6ES7613-1CA02-0AE3
CPU 614
6ES7614-1AH03-0AB3
C7-633 DP
6ES7633-2BF02-0AE03
C7-635 Key
6ES7635-2EC01-0AE3
6ES7635-2EC02-0AE3
C7-635 Touch
6ES7635-2EB01-0AE3
6ES7635-2EB02-0AE3
C7-636 Key
6ES7636-2EC00-0AE3
C7-636 Touch
6ES7636-2EB00-0AE3
3.2 Project engineering
Software versions
At least the following version of STEP 7 is required:
Table 3- 3 Configuration tools for the CP 3431 Lean
STEP 7 versions
Function
STEP 7 V5.5, Service Pack 2, Hotfix 4, HSP 1056 or higher
Requirement for configuration of the CP with the functions
of firmware version 3.0
STEP 7 Professional V11, Service Pack 2, Update 2 or higher
Requirement for configuration of the CP with the functions
of firmware version 2.2