Parameter assignment / addressing
5.2 Creating a project and configuring the communication
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
119
Inserting a further SIMOTION device
If you insert a further SIMOTION device using "Insert SIMOTION device", the PG/PC
interface selection dialog box is not displayed. The second SIMOTION device is
automatically connected to the PG/PC via Ethernet and a new unique IP address (last digit +
1, up to 255) is calculated.
Additional references
Further information on the topic of "Going online" can be found:
● In the online help via the "Contents" tab at
– "Diagnostics" > "Overview of service and diagnostics options" > "Part III" > "Go online"
– "Insert device and connect to target system" > "Go online/offline"
● On the Internet at (http://support.automation.siemens.
com/WW/view/en/22016709)
● In SIMOTION Utilities & Applications, FAQ "Online connections to SIMOTION devices".
SIMOTION Utilities & Applications is part of the scope of delivery of SIMOTION SCOUT.
To Next Page
Loading...
Need help?
General
