Siemens simovert masterdrives - Default Chapter; Table of Contents

10.99 Contents
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES Operating Instructions 1
Contents
1 DEFINITIONS AND WARNINGS .....................................................................1-1
2 DESCRIPTION .................................................................................................2-1
3 FIRST START-UP ............................................................................................3-1
4 TRANSPORT, STORAGE, UNPACKING........................................................4-1
5 INSTALLATION................................................................................................5-1
5.1 Installing the units .............................................................................................5-1
5.2 Installing the optional boards ............................................................................5-4
5.2.1 Installing optional boards on units with a width up to 90 mm ...........................5-4
5.2.2 Installing optional boards on units with a width of 135 mm and 180 mm .........5-7
6 INSTALLATION IN CONFORMANCE WITH EMC REGULATIONS ..............6-1
7 CONNECTING-UP............................................................................................7-1
7.1 Power connections............................................................................................7-4
7.1.1 Power connections for units with a width up to 90 mm.....................................7-5
7.1.2 Power connections for units with a width of 135 mm and 180 mm ..................7-6
7.2 Control connections ..........................................................................................7-7
8 PARAMETERIZATION.....................................................................................8-1
8.1 Parameter input via the PMU............................................................................8-2
8.2 Parameter input via the OP1S ..........................................................................8-5
8.3 Parameter reset to factory setting.....................................................................8-9
8.4 Parameterizing by download...........................................................................8-10
8.5 Parameterizing with parameter modules ........................................................8-11
8.6 Motor lists........................................................................................................8-23
8.7 Motor identification..........................................................................................8-28
8.8 Complete parameterization.............................................................................8-28