Requirements
2.1 Hardware and software components
Getting Started
14 Function Manual, 10/2008, 6SL3097-4AG10-0BP0
L1
L2
L3
Q1
4
PC/PG
352),%86RU&$1RSHQ
QXOOPRGHPFDEHO
'5,9(&/L4
OLQHFRQWDFWRU
OLQHUHDFWRU
OLQHILOWHU
60,PRWRU
).RU3+
&RQWURO
8QLW
OLQHILOWHU
3RZHU0RGXOH
;
;
'2
;
672
;
Figure 2-1 Wiring the components
DRIVE-CLiQ
To assemble the drive unit components, wire the DRIVE-CLiQ cables as follows (for the
wiring, see the example above):
● Attach the CU305 to the Power Module. Make sure that the CU305 is properly secured.
● Connect the SMI motor to the X100 socket on the CU305 by means of the DRIVE-CLiQ
cable.
PG/PC communications interface
● Connect the X22 connector on the CU305 to the serial interface on the PG/PCs by
means of the null modem cable.
To Next Page
Loading...
