Getting Started
Function Manual, 10/2008, 6SL3097-4AG10-0BP0
15
Creating the drive project ONLINE
3
3.1 Creating the drive project ONLINE
The following steps are required to create a drive object ONLINE:
Table 3- 1 Creating a project ONLINE
Step Activity
1 Ensure that the commissioning requirements are fulfilled.
2 Create a project with the help of a Wizard.
3 Carry out an ONLINE search for DRIVE-CLiQ stations.
4 Transfer the configuration to the PG/PC.
5 Operate the motor using the "control panel" in STARTER (motor rotating).
3.2 Requirements
The following prerequisites for creating a drive project ONLINE by means of the STARTER
commissioning tool must be fulfilled:
● The components are assembled (see chapter 2).
● The drive unit has been switched on in accordance with regulations.
● Control Unit CU305 is connected to a PG/PC.
● The STARTER commissioning tool has been called up on the PG/PC.
To Next Page
Loading...
