Creating the drive project ONLINE
3.3 Creating projects ONLINE
Getting Started
Function Manual, 10/2008, 6SL3097-4AG10-0BP0
17
3. In this example, we have selected the RS232 interface for communication. At this point,
make sure that the communications interface is set to "Serial cable (PPI)".
Figure 3-3 Project Wizard: selecting the interface
If it is, choose Continue >. If not, see below.
4. Choose Change and test... and set the serial interface as shown below.
Figure 3-4 Selecting the interface
Choose OK and then Continue >.
To Next Page
Loading...
