Siemens SINAMICS S120 - Page 14

Requirements
Connection Establishment to SINAMICS S120
SINAMICS S120 at Technology CPU Entry ID: 21767896
V1.0 Edition 10/28/05 14/58
Copyright © Siemens AG 2005 All rights reserved
SINAMICS S120 und Technologie-CPU V2.0-SP1__05-10-28_13-20_e.doc
Table 3-2 Configuration of the hardware components in HW Config
No. Instruction Note
1.
In the STEP 7 project, open the
HW Config configuration tool.
2.
In the module catalog, select the
SIMATIC Technology-CPU profile
and insert a Rack, optionally a
power supply and explicitly a
Technology CPU into your project.
3.
Acknowledge the message on the
baud rate by clicking OK.
4.
Address 2 is assigned to the CPU.
Create a new DP(Drive) subnet
using the New button.
5.
Set a transmission rate of
12 MBaud for the DP(Drive) and set
the DP profile.
Subsequently select further settings
for the DP(Drive) using the
Options… button.