1 Alarms 01.02
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
1-26 SINUMERIK 802S/802C (DG)
Channel %1 block %2 activate tool radius compensation in linear block
only
%1 = Channel number
%2 = Block number, label
Tool radius compensation with G41/G42 may only be selected on blocks with
the G function G00 (rapid traverse) or G01 (feed) active.
The block with G41/G42 must contain at least one axis of the level G17 to
G19; always both axes are recommended, since both axes are traversed when
selecting the compensation.
Alarm display.
Interface signals are set.
NC Start inhibited.
Correct the NC program; replace the compensation selection to a block with
linear interpolation.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 deactivate tool radius compensation in linear block
only
Explanation
%1 = Channel number
%2 = Block number, label
The deselection of the tool radius compensation by G40 may only be carried
out in blocks in which the G function G00 (rapid traverse) or G01 (feed) is
active.
The block with G40 must contain at least one axis of the plane G17 to G19;
both axes are always recommended, since usually both axes traverse when
deselecting the compensation.
Alarm display.
Interface signals are set.
NC Start inhibited.
Correct NC program; replace compensation deselection to a block with linear
interpolation.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 do not activate tool radius compensation via
KONT at the current starting point
%1 = Channel number
%2 = Block number, label
When activating the cutter radius compensation via KONT, the start point of
the approach block is within the compensation circle, thus already violating the
contour.
10 753
Explanation
Response
Remedy
Program continua-
tion by
10 754
Response
Remedy
Program continua-
tion by
10 755
Explanation
To Next Page
Loading...
