Siemens SINUMERIK 802S - User Manual

Start-Up 01/2002 Edition
SINUMERIK 802S

Summary

SINUMERIK 802 S Control System

Installing the Control System

2.1 Installing and removing the SINUMERIK 802 S

Provides instructions for the installation and removal of the SINUMERIK 802S control system, including safety warnings.

Installing the STEPDRIVE C Drives

3.1 Installing and removing the STEPDRIVE C drive modules

Instructions for installing and removing STEPDRIVE C drive modules, including mounting dimensions and safety precautions.

3.3 Starting up the drive modules

Start-Up

4.1 General

Outlines the general start-up requirements and sequence for the SINUMERIK 802S control system.

4.2 Turning on and booting the control system

Describes the procedure for turning on and booting the control system, including start-up switch settings and boot messages.

4.3 Starting up the PLC

4.7 Commissioning

Provides guidance on commissioning the control system, including machine data entry and axis/spindle start-up.

Software Update

5.1 Updating the system software using a PC;PG

Explains the procedure for updating the SINUMERIK 802S system software using a PC or programming device.

5.2 Updating the system software incl. user data without using a PC;PG

Technical Appendix

6.1 List of machine and setting data

Provides comprehensive lists of machine data (MD) and setting data (SD) with their default values and parameters.

6.3 PLC user program for turning (UPGMTURN)

Manual Machine

7.1 Hardware and software requirements for the installation

7.2 Loading the software

Provides step-by-step instructions for loading the software, including preparatory work and installation procedures.

Siemens SINUMERIK 802S Specifications