Siemens SINUMERIK 802S - Description of the Logics

Technical Appendix
6.3 PLC user program for turning (UPGMTURN)
6-149
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
M41 M42 M43 M44
O1.4 n
O1.5 n
O1.6 n
O1.7 n
S O0.3 Control output for coolant control
S O0.4 Control output for toolholder (forward)
S O0.5 Control output for toolholder (reverse). The output is activated for
one interval (set in PLC MD) active.
S O0.6 Control output for lubrication system
S O0.7 Alarm output This signal can be used for controlling the step-
switching drives or for display.
6.3.4 Description of the logics
Spindle control
S Input signals:
M03, M04, M05, from part program
M41, M42, M43, M44, from part program
Spindle CW, CCW, Stop, from machine control panel
Spindle->> from machine control panel
Spindle<< - from machine control panel
S Output signals:
Spindle CW (O0.0)
Spindle CCW (O0.1)
Spindle Brake (O0.2)
Spindle speed 1 (O1.0)
Spindle speed 2 (O1.1)
Spindle speed 3 (O1.2)
Spindle speed 4 (O1.3)
S UPGMTURN control