Siemens SINUMERIK 808D ADVANCED Training Manual

Programming and Operating — Turning Page 10 808D ADVANCED
Switch On
And
Referencing
s
Reference
the
machine
If your machine is configured with ABS
encoder, you do not need to reference
the axis of the machine.
If your machine is fitted with INC
encoder, after power on the machine
must first be referenced!
Step 1
After power on, the machine will be
in the reference point approach
mode (default).
If the axis is not referenced, the
non-referenced symbol (circle) is
displayed between the axis identifier
and the value.
Step 2
The axes are referenced with the
corresponding axis traversing keys.
The traversing direction keys are
specified by the machine
manufacturer.
After completing the referencing
procedure for all axes, the referenced
symbol is displayed next to the axis
identifier.
End
After returning to JOG mode,use the
axis traversing keys to move the
machine manually.
Now the machine can be operated in
JOG mode.
During normal operation (JOG),the
reference symbol is not shown on the
screen.
Step 3
SEQUENCE

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English