Service guide 808D turning and millingpage 36
700059
Name of alarm:
Safety door not closed, NC start
not possible.
Address of PLC: DB1600.DBX7.3
Name of subprogram: AUX_MCP(SBR 20)
Fault, running the program without closing the safety door; the result is
that the program cannot be executed.
Check whether the safety door is closed (if using
the safety door control key on the MCP, please
check whether this button is activated).
If the safety door has been closed, please ch
eck the following:
Check terminal X102 on the back of the PPU
1. Whether the connections of pin 7 are loose/disconnected.
Check whether the door-closed limit switch is normal.
Note: Press the
“
Reset
”
button to eliminate the alarm
after eliminating the actual fault.
PLC information
Alarm comment
Processing method
服务指南
服务指南服务指南
服务指南 第
第第
第页
页页
页 车削与铣削
车削与铣削车削与铣削
车削与铣削
故障
故障故障
故障
服务案例
服务案例服务案例
服务案例
注
注注
注:
::
:常见的不可移动刀库的状态
常见的不可移动刀库的状态常见的不可移动刀库的状态
常见的不可移动刀库的状态
主轴正旋转
主轴正旋转主轴正旋转
主轴正旋转
刀库正在执行正转
刀库正在执行正转 刀库正在执行正转
刀库正在执行正转 反转指令
反转指令反转指令
反转指令
主轴正在执行松刀指令
主轴正在执行松刀指令主轴正在执行松刀指令
主轴正在执行松刀指令
系统急停状态激活
系统急停状态激活系统急停状态激活
系统急停状态激活
报警名称
报警名称报警名称
报警名称:
刀库或主轴未就绪时,
启动刀库运转。
报警解说
PLC 信息
PLC 地址:DB1600.DBX4.1
子程序段名称:DISK_MGZ_M(SBR 60)
故障,刀库或者主轴未准备就绪的时候,按下了刀库移动键。
表现为刀库不可移动。
PLC 信息
PLC 地址:DB1600.DBX4.2
子程序段名称:DISK_MGZ_M(SBR 60)
处理方法
报警名称
报警名称报警名称
报警名称:
程序段搜索后,
主轴不等于编程刀号。
检查当前程序中即将激活的刀具号选择是否与当前主轴上装载的刀具一致
报警解说
故障,主轴上的刀号与程序中编程刀号不一致。
表现为出现报警,程序不可继续执行。
处理方法
确认已使用正确的“程序搜索”方法重启程序
按“复位”键可取消该报警,然后继续进行操作
所有信息核对正确后,可按“复位”键取消该报警
Service case
of PLC alarm