Siemens SINUMERIK 808D - Page 49

808D Page 49 Operating and Programming — Milling
Create Part
Program
Part 2
s
Basic Theory
With the “OK” SK, the values and cycle call will be trans-
ferred to the part program as shown below.
This will perform milling at the position defined in the
cycle.
The easiest way to
mill a slot is to use
the SLOT2 cycle.
The cycle can be
found and parame-
terized via the “Mill.”
SK.
The relevant cycle
can be found using
the vertical SKs on
the right.
Select “slot”
using the vertical
SKs and parameter-
ize the cycle accord-
ing to requirement.
Milling slots
and spigots