Siemens SINUMERIK 810D

HMI alarms
11/2006 Overview of Alarms
2-631
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
101636 Write access only in start-up state Download (p10=29).
Definitions: --
Remedy: --
101637 Parameter must not be written in download.
Definitions: --
Remedy: --
101638 Write access only in start-up state Drive Configuration (device: p9=3).
Definitions: --
Remedy: --
101639 Write access only in start-up state Drive Type Definition (device: p9=2).
Definitions: --
Remedy: --
101640 Write access only in start-up state Data Block Base Configuration
(device: p9=4).
Definitions: --
Remedy: --
101641 Write access only in start-up state Device Configuration (device: p9=1).
Definitions: --
Remedy: --
101642 Write access only in start-up state Device Download (device: p9=29).
Definitions: --
Remedy: --
101643 Write access only in start-up state Device Parameter Reset (device:
p9=30).
Definitions: --
Remedy: --
101644 Write access only in start-up state Device Ready (device: p9=0).
Definitions: --
Remedy: --
101645 Write access only in start-up state Device (device: p9 unequal 0).
Definitions: --
Remedy: --
101646 No parameterization enable
Definitions: --
Remedy: --