Siemens SINUMERIK 810D - Page 823

PLC alarms
11/2006 Overview of Alarms
2-823
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
401901 Parameter BAGNo impermissible in FC19
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
401902 Parameter ChanNo impermissible in FC19.
Definitions: The parameterized channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
402401 Parameter BAGNo impermissible in FC24
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
402402 Parameter ChanNo impermissible in FC24.
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
402501 Parameter BAGNo impermissible in FC25
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
402502 Parameter ChanNo impermissible in FC25.
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.
402601 Parameter BAGNo impermissible in FC26
Definitions: The parameterized mode group, channel does not exist.
Reaction: Alarm display.
Remedy: Correct the parameter.
Program
Continuation:
Switch control OFF - ON.