Siemens Sinumerik 840 sl

Starting Up HMI Embedded (IM2) 08/2005
Contents
© Siemens AG, 2005. All rights reserved
IM2/iv SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
4.4 Switching channels .............................................................................................................. IM2/4-43
4.4.1 Multiple channels on 1 NCU ............................................................................................ IM2/4-43
4.4.2 Configuration example for NETNAMES.INI ..................................................................... IM2/4-44
4.5 Selecting tool management.................................................................................................. IM2/4-48
4.6 Fine tool offset ..................................................................................................................... IM2/4-49
4.7 Making tool offset active immediately .................................................................................. IM2/4-49
4.8 Selecting tools via a D number (flat D no.)........................................................................... IM2/4-49
4.9 Workpiece templates ........................................................................................................... IM2/4-50
4.10 Analog spindles.................................................................................................................. IM2/4-50
4.11 Work offset......................................................................................................................... IM2/4-51
4.11.1 Changing access protection to Base Offset softkey ........................................................ IM2/4-51
4.11.2 Fine work offset and base offset...................................................................................... IM2/4-51
4.11.3 Preset actual value memory, preset, scratching.............................................................. IM2/4-52
4.11.4 Hiding machine axes ....................................................................................................... IM2/4-54
4.11.5 Displaying geometry axes................................................................................................ IM2/4-54
4.12 Specifying machine and rotary axis positions .................................................................... IM2/4-55
4.13 Program simulation............................................................................................................ IM2/4-56
4.13.1 Turning simulation and program test ............................................................................... IM2/4-56
4.13.2 Turning/milling simulation ................................................................................................ IM2/4-56
4.13.3 Milling simulation 3D graphic........................................................................................... IM2/4-57
4.14 Measuring cycle support in the G code editor.................................................................... IM2/4-57
4.15 Coordinate systems ........................................................................................................... IM2/4-58
4.15.1 Actual value display......................................................................................................... IM2/4-58
4.15.2 Position of coordinate system.......................................................................................... IM2/4-58
4.16 Displaying and editing system resources........................................................................... IM2/4-60
4.16.1 Static user memory (SRAM)............................................................................................ IM2/4-60
4.16.2 Dynamic user memory (DRAM)....................................................................................... IM2/4-64
4.17 Remote diagnosis "RCS Host-Embedded / RCS Viewer-Embedded"................................ IM2/4-67
4.17.1 Configure "RCS Host Embedded" ................................................................................... IM2/4-69
4.17.2 Installing and configuring "RCS Viewer Embedded"........................................................ IM2/4-71
4.17.3 Start remote diagnosis..................................................................................................... IM2/4-73
4.18 Available display machine data.......................................................................................... IM2/4-75
5 Creating In-House Alarm Texts............................................................................................. IM2/5-95
5.1 Alarm, user, message text files............................................................................................ IM2/5-96
5.1.1 Storage of text files ........................................................................................................... IM2/5-96
5.2 Number ranges of text files.................................................................................................. IM2/5-98
5.3 Syntax of text file.................................................................................................................. IM2/5-99
5.3.1 File name .......................................................................................................................... IM2/5-99
5.3.2 Example of an alpu.txt file................................................................................................. IM2/5-99