08/2005 Starting Up HMI Embedded (IM2)
7 Data Backup
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
IM2/7-113
Areas
NC General NC-specific data
CH Channel-specific data (unit corresponds to the channel
number)
AX Axis-specific data (unit corresponds to the number of the
machine axis)
TO Tool data
COMPLETE All data of an area
INITIAL Data for all areas (_N_INITIAL_INI)
Types
TEA Machine data
SEA Setting data
OPT Option data
TOA Tool data
UFR User input frames: Settable Work offset, rotations, etc.
EEC Measuring system error compensation
CEC Sag/angularity compensation
QEC Quadrant error compensation
PRO Protection zone
RPA R parameters
GUD Global user data
INI General initialization program (all data in the active file
systems)
_N_COMPLETE_TEA Archiving of all machine data
_N_AX_TEA Archiving of all axis machine data
_N_CH1_TEA Archiving of the machine data for channel 1
_N_CH1_GUD Archiving of the global user data for channel 1
_N_INITIAL_INI Archiving of all data in the active file system
References: /IDsl/ Installation and Start-up Manual CNC Part 1 (NCK, PLC,
Drive)
7.1.2 Data backup in HMI Embedded
All furnished drives are available for a data backup.
As a general rule, all modified files and programs are stored directly on the
CompactFlash card in a permanently defined tree structure. From there, they can
be copied to other memory locations over the set up drives.
Procedure
Use the same procedure as described in the “Series start-up” section.
To Next Page
Loading...
