Siemens SINUMERIK 840D pl - Page 949

3-949
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
List of Action Numbers 3
The following list describes the actions stated in the alarm texts under "Action %.."
according to their numbers.
No. 1
No. 2
No. 3
No. 4
Explanation Run Init phase (tasks are initialized after power on).
Not allowed if -
Remedy -
Explanation Perform reset (VDI signal: Reset, mode group reset or after power on).
Not allowed if -
Remedy -
Explanation Activate Reset Init blocks (VDI signal: Reset).
Not allowed if -
Remedy -
Explanation Perform reset, end of program has been detected (NC block with M30).
Not allowed if -
Remedy -