Overview of Alarms 08/2005
2-30
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
• LINK_BAUDRATE_SWITCH,
• SYSCLOCK_CYCLE_TIME
The values of these machine data must be the same on all NCUs.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: The machine data required for the link module configuration must be the same on all
NCUs in the cluster.
Program Con-
tinuation:
Switch control OFF - ON.
4014 Axis %1 defined several times in %2
Parameters: %1 = String: MD identifier
%2 = String: Check and, if necessary, correct the following machine data with reference
to the data sheet:
Definitions: An axis was assigned several times.
The axis can be a:
• Machine axis
•Link axis
• Axis in a container location
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Define a correct, unique axis assignment.
Program Con-
tinuation:
Switch control OFF - ON.
4016 Axis %1 already used by NCU %2
Parameters: %1 = Machine axis index
%2 = NCU number
Definitions: An attempt was made to apply setpoints to one axis from several NCUs. Only occurs with
the NCU link system
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Define a correct, unique axis assignment.
Program Con-
tinuation:
Switch control OFF - ON.
4017 Axis container %1, location %2 already used by NCU %3
Parameters: %1 = Axis container number
To Next Page
Loading...
Need help?
General
