Siemens SINUMERIK 840D sl Series User Manual

Overview of Alarms 08/2005
2-52
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
%2 = String: MD identifier
%3 = No. of output
Definitions: The specified machine data assign two NC functions to the same digital/analog output.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Correct machine data.
Program Con-
tinuation:
Switch control OFF - ON.
4280 Assignment of NCK input/output byte via MD %1[%2] does not match hardware
configuration
Parameters: %1 = String: MD identifier
%2 = Index: MD array
Definitions: When booting, the required input/output module was not found at the slot specified in the
MD.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Check hardware and correct
the MD if necessary. Note: Monitoring of the hardware configuration is performed inde-
pendently of the number of activated inputs/outputs (MD 10300 - 10360
FASTIO_ANA(DIG)_NUM_INPUTS(OUTPUTS))
Program Con-
tinuation:
Switch control OFF - ON.
4282 Hardware of external NCK outputs assigned repeatedly
Definitions: Several outputs have been configured on the same hardware byte.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Alter MD 10364
HW_ASSIGN_DIG_FASTOUT or MD 10364 HW_ASSIGN_ANA_FASTOUT.
Program Con-
tinuation:
Switch control OFF - ON.
4285 Error on terminal block %1, error code %2
Parameters: %1 = Number of terminal block (1 ... 4)
%2 = Error code
Definitions: An error occurred on terminal block no. %1 (sign-of-life failure, I/O module removed in
current operation, etc.). All possible errors which can lead to this alarm are not yet known

Siemens SINUMERIK 840D sl Series Specifications

General

Control Type	CNC
PLC	Integrated SIMATIC S7-300
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Max Axes	31
Programming Languages	DIN/ISO 66025, high-level language (C/C++), Siemens programming languages (e.g., ShopMill, ShopTurn)
Safety Features	Integrated safety functions (Safety Integrated)
Operating System	Windows-based
Drive Interface	SINAMICS S120
Applications	Milling, turning, grinding, laser
Display	TFT color display, various sizes